
>>>>>>>>>>>>>>>>>>>>>>
ElectroSOFT Machine Designer
<<<<<<<<<<<<<<<<<<<<<<

Build time: December-2007.

It is an electrical-machine designing software.

It takes different parameters of a machine as input and calculates the parameters required for the designing purpose and creates a design sheet of that machine. Then according to that design sheet makes a 3D view (drawing) of that machine in AutoCAD application. 

To see the 3D view, the AutoCAD software should be previously installed in the machine.



::::::::::::::::::::::::::::::::::::::::::::::::
Recommended Platform:
::::::::::::::::::::::::::::::::::::::::::::::::

Windows XP (with Service Pack 2) or any upper versions.


::::::::::::::::::::::::::::::::::::::::::::::::
Recommended Hardware requirements:
::::::::::::::::::::::::::::::::::::::::::::::::

16MB RAM, Pentium-133 MHz, 10 MB Hard Disk.
As this software works together with AutoCAD software, the requirements for AutoCAD software should be met.


::::::::::::::::::::::::::::::::::::::::::::::::
Recommended version of AutoCAD:
::::::::::::::::::::::::::::::::::::::::::::::::

*AutoCAD-2002 or any upper version supports all the features of ElectroSOFT Machine Designer.
*Other lower versions upto AutoCAD-14 may also be used to run this software but may not support all the features.


::::::::::::::::::::::::::::::::::::::::::::::::
Evaluation limitations (applicable for Evaluation version):
::::::::::::::::::::::::::::::::::::::::::::::::

200 executions of this software are available.



Please send suggestions about improvement of this software to the following e-mail address:
saikatadak2004@yahoo.co.in


If this software be useful, please order for it to:

	Saikat Adak
	E-Mail - saikatadak2004@gmail.com
	Mobile - 09885004387
	Resi - (033)65456277

